Sigma SG-50C Coin Hopper Jam
colorado:
Hello,
I have a Sigma SG-60C and have been getting a hopper error and a tilt message.
I have observed the hopper as it functions and notice the coins getting jammed between the small post on the hopper platter and the knife blade.
I have attached a photo to help explain.
Does anyone have any suggestions ??
Thank you ....
Colorado
proten:
Looks like the pin wheel is for the
large IKE dollar coin.
colorado:
Thanks for the reply.
Is that determined by the spacing between the posts.
I just bought this machine yesterday. It seems like the previous owner
Would have had trouble with this machine running quarters through it
With a hopper configuration for dollar coins.
Do you know what I would have to do to configure the
Hopper to a quarter pinwheel.
Colorado
proten:
You will need to change the pin wheel for
a quarter pin wheel. Put a WTB for a pin
wheel or a complete hopper and a member
here will help you out.
colorado:
Okay. Thank you very much.
I will do that today.
Do you know if the pinwhee is specific to sigma hoppers.
Navigation
[0] Message Index
[#] Next page