|
Title: X-Arcade Stick Info Post by: channelmaniac on September 16, 2008, 12:50:42 AM Model: 2 player stick
(Can be PC, PS2, XBOX as they are all the same other than the external connector cable) Board was labeled MOD-1234 XGAMINGtm -- Ages ago I scrapped out an X-Arcade 2 player control and turned it into a JAMMA testbed for repairing and testing game boards. When I disassembled the unit I took tape and made little tape flags for each wire and wrote what they were for on the flags. I also marked the harness connector and the board connector with different colors and location of marks to keep the harness and the board location together. However, I don't remember if the buttons were labeled left to right or from top to bottom. I think left to right. One big caveat for wireing these controllers is: DO NOT CONNECT THE GROUNDS TOGETHER. The grounds on each connector are ONLY for the wires on that connector. These are forming a matrix and if you connect the grounds together you short that matrix. JP2: TBSA (these letters are silkscreened on the pc board next to the various jacks) 1 - gnd 2 - 1P Start 3 - Left Pinball Flipper 4 - 2P Start 5 - Right Pinball Flipper JP3: PMRQ 1 - gnd 2 - P2 Button F 3 - P2 Button H 4 - P2 Button C 5 - P2 Button G JP4: ONLK 1 - gnd 2 - P2 button A 3 - P2 button B 4 - P2 button D 5 - P2 button E JP5: ZY1YZ1 1 - gnd 2 - P2 Up 3 - P2 Down 4 - P2 Left 5 - P2 Right JP6: HEJI 1 - gnd 2 - P1 Button F 3 - P1 Button H 4 - P1 Button C 5 - P1 Button G JP7: GFDC 1 - gnd 2 - P1 Button A 3 - P1 Button B 4 - P1 Button D 5 - P1 Button E JP8: VXUW 1 - gnd 2 - P1 Up 3 - P1 Down 4 - P1 Left 5 - P1 Right JP9: selector switch JP10: LED / LOAD 1 - LED gnd 2 - LED + 3 - nc 4 - Back Panel button 5 - Back Panel button |