Atronic - Emotion - touch screen

(1/1)

Skipper:
Dear friends from the forum and I appreciate any help or reach, my problem is that I have a touch of General card machine monitor Atronic emotion model, the fault is not calibrate the touch, has been excluded, and the fault is in the controller card, attached a photo.
thanks

ChizzleMonkey:
Controller card has programmed chip, needs to be programmed usually by manufacturer. You can get empty chip and copy over to it.

ROULHAND:
Hi. I have some Atronic cashfevers that all have touchscreen problem. I normally have to remove all screens, clean them and restart. After cleaning and  restarting they all start working again,but after a week back again to the same issue. No touch at all. Most of them are new screens with new touch controllers too. So I dont know what cause my touchscreens to stop working. Its definitely not the power supplies. Any ideas where to look for this fault would be appreciated. They stay on 24hours.

Does anyone know where I can get the progressive calculation sheet to program the APL with the correct settings.

Thanks
Deon

Navigation

[0] Message Index