NRI G13 mft parallel teach mode
Oscar Pompa:
Does anybody know an easy way to program the coin validator G13 from NRI ? :103-
i already read the 72 pages manual and im more confuse than before, im gonna start the second reading....
:279-
thank you for your help.... :99-
kondy73:
I work with NRIs very often. In the G13mft parallel whether the settings of a particular piece permitted outside teach mode via DIP switch.
If yes then this is easy if it is not enabled, then without diagnostics tool this impossible.
Do you have WinEmp diagnostic software and cables for G13mft connecting to PC?
Alternatively write me to kondy73@gmail.com, I need good photos of your G13mft models e.t.c (what current use "datablock" and other things".
Oscar Pompa:
I tried the Dip Switch teach mode, I already pass that part with Ok Results (the one click) but , after you teach, how do you put that chanel to work?? :103-
I didnt try to download the WinEmp because i dont have the cables to connect to the PC.
:208-
attached is one picture of the G13 model, thank you for the help. :88-
kondy73:
ok I look which channel (s) can teach in external dip teach mode is used when the data block is 14009235 on your photo.
kondy73:
So your datablock 14009235 (if is original factory G13) can teach coins DIP channel S2.6 , S2.7 and S2.8 .
If someone reprogramed your G13 or changed datablock via WinEmp, then will not be used to teach or listed below do not apply , or is changed.
Also, if your G13 does not reliable accept preset coin GBP (block0) or EUR (block1) will not work well also teach mode, because it is faulty.
DIP channels S2.6 - S2.8 in your datablock they can send 1 pulse duration of 100 milliseconds to HW channel number 6 (parallel channel 6).
You can not change the pulse duration or number HW channel without WinEMP .
For these 3 DIP channels (S2.6 - S2.8) you can teach 3 types different coins but all send to machine in time accepting only 1 pulse 100 milliseconds to HW channel number 6.
Procedure teach :
- Switch all DIP switch down to the OFF position except S1.10 so that the activated Block1 where you can do teach .
- switch on the power supply G13 in vertically best in machine holder and set S2.9 - to up - ON position ( teach mode)
- If want G13 to teach coins which you have in hand to only a few (10 pieces in one type) , then set S2.10 switch up -on (Teachband wide)
- If want G13 to teach coins which you have in hand least 20 pieces , then let S2.10 down - off (Teachband normal )
- set DIP channel that want to teach (S2.6 , S2.7 and S2.8) into position up - on.
- you throw a coins of the same kind, always after thrown 10 pieces, clicks acceptance gate 1*, you can throw further if you have more pieces in better teaching. Every 10 pieces clicks again.
-After last one click of gate set the DIP S2.9 (teach mode) to the OFF position down.
- If teaching is right, then 1* clicks acceptance gate, If 2* clicks where a mistake was another example coin type or other error, you repeat the procedure.
After successfully teach, you set all DIP switchs to OFF except S1.10 (block1 active), it must still be in the ON position, otherwise you can not use new channels.
If you 100 milliseconds, number HW channel does not comply, or you want to change the settings, contact me or buy original cable for WinEmp in manufacturer.
Navigation
[0] Message Index
[#] Next page