How to permanently bypass S2000 door optics

<< < (17/17)

T:
Quote from: Neonkiss on December 16, 2013, 09:29:22 PM

Here is a picture of proper tooling and harness.

Nice, just to clarify, the connector on the left connects behind reels # 1 door optic plug. The wire runs over to the cabinet optic connector and plugs in. The other short wire runs to the Cherry switch. Is that 2 spade connectors on the end or one spade connector and something else. It would need 2 spade connectors right?

cowboygames:
Two female spade connectors is what you'll need

Buzz:
If you look top right Neon already has spade connectors installed.

T Now forget everything you have ever read about bypassing door optics. Try this using only one piece of wire about 5 feet long ( you don't need welding cable 26/28 ga is plenty big enough ) OK now remove about 3/8 of a inch of insulation on both ends of this new wire. Unplug the door optics, stick the bare end of the wire into the optic plug hole that has the RED wire and plug the cptic back together. do the same thing with the other end of the wire at the cabnet optics but this time it goes into the hole with the Green wire.

Your optics are now bypassed Now if you want to get fancy, cut your new wire close to the cabinet optic but make sure the wire will be long enough to reach the cherry switch. Put a spade terminal wher you cut your new wire and slide the spade onto the cherry switch. Do the same thing with the other end of the cut wire and put in on the other terminal of the cherry switch.

Neonkiss:
Quote from: T on December 17, 2013, 12:48:05 AM

Is that 2 spade connectors on the end or one spade connector and something else. It would need 2 spade connectors right?

T- ya, it does look funky in my picture as the second spade connector is on its side.
But yes, two spade connectors

Navigation

 Message Index