S2000 - Install a FutureLogic GEN1 printer

<< < (3/3)

89chevyman:
Not sure its enabled. Did not see a prompt in the menus. This is why I question the need for the key 17. I know this usually opens up more menus so I'm going to give it a shot tonight. Or a better question, HOW do I tell or how can I accomplish this?

Harvs:
Quote from: 89chevyman on January 31, 2014, 12:21:01 PM

Not sure its enabled. Did not see a prompt in the menus. This is why I question the need for the key 17. I know this usually opens up more menus so I'm going to give it a shot tonight. Or a better question, HOW do I tell or how can I accomplish this?

Press the white button on the MPU, go to KEYCHIP Config II, then go to 7.2.2 printer and see if it says ENABLED.

*Also, make sure the grey ribbon cable running to the back of the printer is seated properly. Along with the harness on the bottom that runs to the Netplex.

Harvs

Navigation

 Message Index