IGTSlot: JCM dbv-145ss Connector Wiring Information
(1/1)
classiccars:
New IGT S-Plus machine to me. It has a JCM dbv-145ss Bill Acceptor installed. It is currently dead, does nothing. The JCM power supply is/was bad. Waiting for replacement to see if this bill acceptor works.
My question is about the wiring going to the unit. It has two Molex connectors. (A 6 pin connector from the power supply and a 14 pin connector.) The 6 pin connector has all six wires installed. The 14 pin connector has only two wires installed. (I beleive pin 8 ((LED+)) and pin14 ((TTL Output 6)) ) Does this seem correct or should there be more wires installed into this 14 pin connector?
Is there a place were I can find a wire diagram/schematic for this IGT S-Plus slot that would should the wiring layout for the Bill Acceptor?
Thanks
poppo:
I replied to your PM and questions about the wiring.
Navigation
[0] Message Index