IGT S+ POWER SUPPY VOLTAGE CHANGE

(1/2) > >>

Slottex:
DOES ANY ONE HAVE A WIRING DIAGRAM FOR CHANGING  A S+ POWER SUPPLY FROM 240V TO 120V , ANY HELP WOULD BE APPRECIATED !

THANKS DANNY :103-

stayouttadabunker:
You don't need a diagram, all you need is NLG  :72- ...open the power supply (PLEASE make sure the power cord is disconnected first!)
Remove the Black/purple stripe (# 29) wire from the coil.
Follow it down to the floor...the other end of it will be plugged into the black bus on the floor.
Pull it out of there too and your power supply is now 115Vac.

Slottex:
Thank's for your help been awhile since I had to change one.

Thanks Again  K+ :131-

stayouttadabunker:
Do you have a voltage tester on hand?
Always double check with one BEFORE putting it back in the machine.
Let me know your tester results for verification.

Jim:
Danny     I'm a little late in posting this but something  for the future.    Jim

Navigation

[0] Message Index

[#] Next page