|
Title: Jumper settings for a Bally 5500 Post by: Dennoman on November 03, 2013, 12:21:35 AM Does anyone know the proper settings for the jumpers JW1 through JW14? Which do you go with from the manual, Position 1 or Position 2?
Tks Title: Re: Jumper settings for a Bally 5500 Post by: proten on November 03, 2013, 12:48:28 PM Here is the manual for the S5500 to down load.
http://newlifegames.net/nlg/index.php?action=downloads;cat=101 (http://newlifegames.net/nlg/index.php?action=downloads;cat=101) Here are the settings for the S5500. Jumper Shipping Position Purpose P1 P2 JW1 OUT External Antenna IN OUT JW2 IN Wait State IN OUT JW4 512K EPROM Size 256K 512K JW5 512K EPROM Size 256K 512K JW6 512K EPROM Size 256K 512K JW8 IN PCB Antenna IN OUT JW9 RS-232 Serial Standard RS-232 RS-422 JW10 IN SafeRAM™ Clear (unused) IN OUT JW11 OUT VBB Door Open Latch IN OUT JW12 OUT Battery IN OUT JW13 IN SafeRAM™ Key IN OUT JW14 IN VBATT to RAM IN OUT Title: Re: Jumper settings for a Bally 5500 Post by: Dennoman on November 03, 2013, 07:37:33 PM So this is where I'm confused. Do you go with the P1 settings or the P2? What do P1 and P2 stand for? Tks
Title: Re: Jumper settings for a Bally 5500 Post by: proten on November 04, 2013, 03:37:17 AM Position 1
Position 2 Title: Re: Jumper settings for a Bally 5500 Post by: Dennoman on November 04, 2013, 09:53:46 AM I'm sorry, I should have been clearer. What is the reason I would pick P1 or P2 for my settings?
|