Welcome, Guest. Please login or register.
May 03, 2024, 01:36:57 PM

Login with username, password and session length
* Home Help Arcade Login Register
.
+  Forum
|-+  Arcade Games, Pinball, Crane Games, Redemption Games and Other Stuff
| |-+  Other Arcade Games
| | |-+  Cherry Master Help		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Go Down Print
Author Topic: Cherry Master Help  (Read 4744 times)
curtm73
New NLG Member 1 to 100 Post
**

Total Karma Storms: 0
Offline Offline

Posts: 8
« on: June 06, 2013, 08:20:38 PM »
Hi folks,

I just purchased a used countertop Dyna Cherry Master machine for my rec room. It has an older bill acceptor that doesn't work. Is there a way to add credits to the machine without having to put money in? There was no paper work with this unit, so I need to rely on the internet for any and all help. I will post pictures of the machine later.
Logged
BR549 Auto Sales
Contributing NLG Member
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 499
Offline Offline

Gender: Male
Posts: 1903
« Reply #1 on: June 06, 2013, 11:30:25 PM »
You should be able to run 2 wires from credit wires of the wiring harness, (may also be labeled as coin 1 or coin 2) on your wiring harness and drill a 1 1/8" hole on the side or rear of the machine to bring the wires back to and install a button with a micro switch and just add credits to the game by pressing that button. As far as your bill acceptor on the machine will it cycle at all? do you hear it running when you power up the machine, will it pull in a bill and send it back out? If you can, post a picture of the front of the game and then open up the hatch below the control panel and take a picture of the bill acceptor to and post it.
Logged
curtm73
New NLG Member 1 to 100 Post
**

Total Karma Storms: 0
Offline Offline

Posts: 8
« Reply #2 on: June 07, 2013, 01:42:56 AM »
I will post some pictures tomorrow...The bill acceptor is on, but the money only goes in maybe 1/4 of the way. It makes a clicking sound.

I am not the most tech savvy person, so adding a couple wires may be out of my league (unless you just plug them in).

Again, I will post multiple pics of the inside of the machine tomorrow.
Logged
BR549 Auto Sales
Contributing NLG Member
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 499
Offline Offline

Gender: Male
Posts: 1903
« Reply #3 on: June 07, 2013, 02:11:38 AM »
Well it may just be easier to pick up a working bill acceptor and replace the one you have, probably get one for 50.00 or less.
Logged
curtm73
New NLG Member 1 to 100 Post
**

Total Karma Storms: 0
Offline Offline

Posts: 8
« Reply #4 on: June 11, 2013, 01:14:07 PM »
Pics of the bill acceptor. It powers on, but only takes a bill in a fraction of the way.

* 044.jpg (23.91 KB, 360x240 - viewed 301 times.)

* 045.jpg (22.88 KB, 360x240 - viewed 325 times.)
Logged
curtm73
New NLG Member 1 to 100 Post
**

Total Karma Storms: 0
Offline Offline

Posts: 8
« Reply #5 on: June 11, 2013, 01:35:38 PM »
Here is a pic from the front where the game board is, and a pic from the back

* 049.jpg (37.7 KB, 360x240 - viewed 344 times.)

* 053.jpg (27.34 KB, 360x240 - viewed 311 times.)
Logged
Ron (r273)
NLG Welcome Wagon & General Chat
Senior Full time Member.
Sr.Tech NLG Member 1000+ Post
*

Total Karma Storms: 401
Offline Offline

Gender: Male
Posts: 1819
« Reply #6 on: June 11, 2013, 02:36:06 PM »
Don't think this will help you but here are some installation instructions on your bill validator, for your library.

Ron (r273)
* BVD HSV 300.zip (51.25 KB - downloaded 622 times.)
Logged
asgard
New NLG Member 1 to 100 Post
**

Total Karma Storms: 9
Offline Offline

Gender: Male
Posts: 91


Gaming Machine Owner / Operator
« Reply #7 on: June 12, 2013, 11:39:31 PM »
Pin 18 on the solder side and a ground will put credits on, pin 21 on the solder side and a ground will take off credits.
Logged
Pages: [1] Go Up Print 
« previous next »
Jump to:  

SimplePortal Classic 2.0.5

If you find this site helpful, Please Consider Making a small donation to help defray the cost of hosting and bandwidth.



Newlifegames.com ™    Newlifegames.net ™    Newlifegames.org ™
   New Life Games ™    NewLifeGames ™  NLG ™ We Bring new Life to old Games ™    1-888-NLG-SLOTS ™
Are all Copyright and Trademarks of New Life Games LLC 1992 - 2021


FAIR USE NOTICE:

This site contains copyrighted material the use of which has not always been specifically authorized by the copyright owner.
We make such material available in an effort to advance awareness and understanding of the issues involved.
We believe this constitutes a fair use of any such copyrighted material as provided for in section 107 of the US Copyright Law.
In accordance with Title 17 U.S.C. Section 107, the material on this site is distributed without profit to those
who have expressed a prior interest in receiving the included information for research and educational purposes.

For more information please visit: http://www.law.cornell.edu/uscode/17/107.shtml.

If you wish to use copyrighted material from this site for purposes of your own that go beyond fair use,
you must obtain permission directly from the copyright owner.

NewLifeGames.net Web-Site is optimized for use with Fire-Fox and a minimum screen resolution of 1280x768 pixels.


Powered by SMF 1.1.20 | SMF © 2013, Simple Machines
Loon Designed by Mystica
Updated by Runic Warrior
Page created in 0.096 seconds with 20 queries.