S2000 multi-denom software setup
<< < (2/3) > >>
Railroad94:
No Ram Clear is needed each time you change these settings.

Check out the old post on multi-denom

http://newlifegames.net/nlg/index.php?topic=3406.0
Slottex:
Thanks for the info got it going was having problems with using 1&3 and 2&4 on the touch pad, but all is well now THANKS!!!!!!!!!!

Thanks Again Danny
Buzz:
To recap Paul is trying to set a S 2000 for touch pad multi denom. The values he is wanting are  .01, .02,    With a whole lot of trial and error I've figured a way to do this.
                                                                                                                                      .01. .05

I used a machine with a SB****  , SG000363, & VS011GX1   Start out doing a clear with a 097 and use a Key 31 to get into key menu. With the base chip back in machine. start set up.

7.1.1.1 accounting    set at .01
7.1.1.2 coin denom.  set at .05   ( note you folks with coin handling the amount you set coin denom at is the amount of credits you will receive for each coin dropped into hopper. Example
                                                set coin denom at $100.00 and you will receive same credits as a $100.00 bill inserted in the BV)
7.1.1.3 Player denom. set player #1 at .01  player #2 at .02  leave player #3 disabled, player #4 .05 ( now we have to skip a step and then go back )
7.1.2    Game selection  Set players #1,#2, & #4 to your desired pay %
7.1.1.4  Touch panel    surf through the different options using the cash out and/or call buttons until you see 1/3 assign this to .01 press max bet and save, then go back into 7.1.1.4 surf through the options and find button #2 assign this button to .02 , max bet to save back into 7.1.1.4 and assign button #4 to .05.

Remember in 7.1.1.3 we left player #3 disabled, but with this setup it's not disabled anymore.
 I would think this is a hard way to do all this, but it works !!   ( Please note you have been in clear/key menu, don't forget to set machine type Upright/Slant Top, and turn your printer on in config II (unless you want to use the key chip again )

If I forgot anything, just remember I'm OLD, I have a excuse
StatFreak:
 :259- Buzz for putting it all in one concise post.


Topic moved and stickied.

Stat :31-
paul:
Strat Where did you move topic and why was it moved
Navigation
Message Index
Next page
Previous page