|
Title: netplx auto config Post by: davidgeorge58 on December 13, 2010, 05:07:41 PM Hello to all ,
I an looking for some help. i have a S 2000 W/ cashflow head cant get the net plex to auto config. I get not responding . i have changed out the following game brd, mother brd, bv head , bv IF card, ribbin cable , small com brd on the card cage . any help ...please im stumped!!! Title: Re: netplx auto config Post by: stayouttadabunker on December 13, 2010, 06:55:44 PM Need more info...at the very least.
What are the ID numbers on the DBV? Title: Re: netplx auto config Post by: davidgeorge58 on December 13, 2010, 11:11:29 PM Hey thanks ,
the game was up just a day ago ,something must of blew, but im not sure what happened,i have replaced all the major componets and the usual suspects ,checked the settings,mabee i have forgot something Title: Re: netplx auto config Post by: brichter on December 14, 2010, 03:17:05 AM You still haven't answered the question: What are the ID numbers on the DBV?
Title: Re: netplx auto config Post by: KreepLX on December 14, 2010, 04:07:10 PM The MEI Cashflow has a board behind the BV head. You can reach your hand in there and pop it out with your hand. If you changed out your motherboard and everything else, it may be the issue. I have seen those occasionally fail and it is very simple to change. If swapping that doesn't work, check your harnessing and look at your other Netplex devices because they are on a parallel BUS. **You already stated interface card, ugh**
Oh, BTW.. don't even bother with your COM ports via the ribbon cable. Check the pins on your processor. You may have a short on the Netplex BUS so look at your VFD and Thermal Printer. Unplug each Netplex device and test by listening for the BV cycle after a powering on and off. Title: Re: netplx auto config Post by: davidgeorge58 on December 15, 2010, 02:46:03 PM m# sc6602 PT# 62542590 IDO 24 sc66f v1.30 cruise ,Cash flow SC series thanks David
Title: Re: netplx auto config Post by: davidgeorge58 on December 15, 2010, 03:18:27 PM BV cyles fine,green light comes on ,BV is working , netplex wi confgure any thing , im going to S/O the PS now ,i think thats the only thing left /
Title: Re: netplx auto config Post by: davidgeorge58 on December 16, 2010, 03:04:31 PM Good morring to all ,
Thanks for all your help .I found out the problem. when my tech reseated the BV IF card he somehow pushed back pins #4 or 5 on the female side of the plug .i dont know why i looked back there ,but that is were the fault was! Title: Re: netplx auto config Post by: stayouttadabunker on December 16, 2010, 04:45:38 PM Your tech has a new nickname then...."Pin-Head".... :96-
|