|
Title: S+ Error code [63] with an SP1213 Post by: stayouttadabunker on March 09, 2011, 02:53:49 PM How about this? :72-
After all these years, this is the FIRST time I ever got this error code [63]. :285- Anyways, in the PSR for the SP1213 chip, it states that the error code [63] is : "Card cage and Main Door Open" :97- wow! I didn't know that I'd run into this! Anyways, now I gotta find the pins on the motherboard and bypass the bloody card cage switch because I KNOW my optics are fine. It's kinda of hard to do when there's no actual "switch" installed in the machine.... :208- Attached below is a terrible photo I took with a "keyfob spy cam"...lol You can't even tell if you're taking level photos with the tiny thing. Arghh! But it will show the error >>> Title: Re: S+ Error code [63] with an SP1213 Post by: stayouttadabunker on March 09, 2011, 04:08:15 PM Okay,
I've researched the S+ manual and found that the J2 header on the motherboard is as follows: Pin#1 24Vac Hot Pin#2 24Vac Return Pin#3 B GND Pin#4 B GND Pin#5 Card Cage Detect Pin#6 Card Cage LED Do I jump across Pins #4 and #5 on the J2 header? :129- Title: Re: S+ Error code [63] with an SP1213 Post by: Jim on March 09, 2011, 04:54:56 PM Bunker that signal from pin 16b goes to R6 on the motherboard then onto J-2 pin 6 don't have the schematic in front of me for the motherboard so I can't say what that means.
Jim Title: Re: S+ Error code [63] with an SP1213 Post by: stayouttadabunker on March 09, 2011, 05:00:13 PM Thanks Jim,
I just made a small Molex jumper and stuck it in the J2 header. I configured the jumper as: Pin #4 to Pin #5 and the error Code [63] went away! :136- Back in business! :267- Title: Re: S+ Error code [63] with an SP1213 Post by: knagl on March 09, 2011, 07:52:56 PM That'd typically be reserved for the WAP games like Wheel of Fortune and Jeopardy and whatnot... Very odd. Title: Re: S+ Error code [63] with an SP1213 Post by: stayouttadabunker on March 09, 2011, 11:33:05 PM Wait til you check out the PSR for it! lol
It's chock load fulla stuff! :91- BTW Works only with a 10MHz MPU board. I tried it first with a 16MHz MPU and got crazy reels.... :96- Title: Re: S+ Error code [63] with an SP1213 Post by: futkorn on July 06, 2012, 02:33:57 PM Good day for all,
this topic helped me a lot, thanks. Title: Re: S+ Error code [63] with an SP1213 Post by: cmosdata on December 30, 2012, 03:19:40 PM very good, thanks.
Title: Re: S+ Error code [63] with an SP1213 Post by: stayouttadabunker on December 31, 2012, 01:21:35 PM Hey! Thanks guys! :71-
I'm glad an old S+ thread of mine helped ya! :89- |