|
Title: mark 5 b/v question Post by: kenokarz on December 11, 2008, 02:18:54 AM i have 2 mark 5s up rights with no b/v they need gpt type assy, try the wba they dont fit does anyone have a pics of the complete assy for what i need ?? if someone has one of these machines could you please post some :99- :99-
Title: Re: mark 5 b/v question Post by: hoppy on April 30, 2009, 08:27:30 AM Hi .There are some MVP mk5 manuals listed on MYSLOTNOTES.COM They may list the type used in the machine. cheers
Title: Re: mark 5 b/v question Post by: kenokarz on April 30, 2009, 10:02:34 AM thanks for the info
Title: Re: mark 5 b/v question Post by: Ozzy on April 30, 2009, 10:59:10 AM Here are a few pictures from a MK5 with GPT S4 bv.
cheers O Z Z Y Title: Re: mark 5 b/v question Post by: kenokarz on April 30, 2009, 11:45:22 AM thanks ozzy, what are the b/v dip settings to be for this one
Title: Re: mark 5 b/v question Post by: Ozzy on April 30, 2009, 12:15:11 PM If you end up with the GPT S4 BV all switches are off (1-10)
but if you locate the earlier model switch 1 to 6 are on and 7 to 10 off. attached is some info on the S4 MK5 also can use WBA bv if you have correct assembly frame for the machine, this would be the best way to go as the GPT software upgrades are done via a download key which is a few $$$$$, check out the web site http://www.gptworld.com/GPT.htm. cheers O Z Z Y Title: Re: mark 5 b/v question Post by: kenokarz on April 30, 2009, 12:39:25 PM what does the wba frame look like for this machine i think this would be a better way to go,
thanks as always Title: Re: mark 5 b/v question Post by: Ozzy on April 30, 2009, 01:20:02 PM Never seen one as all my Aristocrats have the GPT S4, but would imagine it would be this (attachment) you would need to also get hold of the Bill Entry for the door panel and the correct harness.
cheers O Z Z Y Title: Re: mark 5 b/v question Post by: Op-Bell on May 01, 2009, 05:06:36 AM WBA frame is basically two flat plates with spacers at the top and bottom. Not hard to fabricate yourself. However, you would need a few extra parts to make it a full GPT replacement, like the JCM 'G-Pattern Bezel' and a JCM 300-100037 board and harness set. Best to stick with the GPT unless you can pick the WBA kit up as a lot.
<edit> and if you had the hopper shown in Ozzy's picture above, you'd have to work on the bowl, because the WBA needs a cutout about 2 inches deeper. The bowl is ABS and can be softened with a heat gun and bent by hand. Title: Re: mark 5 b/v question Post by: kenokarz on May 01, 2009, 11:14:12 AM thanks i will try that,if anyone has a pic of a mark 5 with the wba please post, mine does not have a b/v no cage or anything
bought as a parts machine and this is my next project to build, the only thing im misssing is the b/v parts |