|
Title: swaping out a s2000 printer-how to remove? Post by: vegasbaby on March 23, 2011, 11:40:46 PM HI
I need to swap out my non working printer for a working printer.What the best way?I have the power off and have pull out the main unit almost to end but it catches at end.Where is the release to pull it always out. THANKS FOR YOUR HELP Title: Re: swaping out a s2000 printer-how to remove? Post by: Buzz on March 23, 2011, 11:52:14 PM Unplug the ribbon cable, release is at the front bottom. push on it while pulling the printer toward you.
Title: Re: swaping out a s2000 printer-how to remove? Post by: vegasbaby on March 24, 2011, 12:42:55 AM Thanks made the swap,powered back up printer front lights up,then shuts off and now I get printer communcation error,what could be causing this problem.I have 700 credits on machine when cashing out printer stoped working.
Title: Re: swaping out a s2000 printer-how to remove? Post by: reho33 on March 24, 2011, 01:41:15 AM If the printer is i right it should NETPLEX auto-config back into configuration. Check in the menus if it is enabled as well.
Title: Re: swaping out a s2000 printer-how to remove? Post by: vegasbaby on March 24, 2011, 01:55:48 AM I think i found the problem,on bottom side of printeris a small brass pc that completly loose,in fact old printer this pc looks like it wore out.Is there away to fix that,or do i need a new printer?Also since the machine has 700 credits on it i cant use the key to bypass the printer.But could i do a complete clear,then use the the key?
Title: Re: swaping out a s2000 printer-how to remove? Post by: Foster on March 24, 2011, 02:00:17 AM if the printer is not working and you cash out (if hopper limit is 0) it will force a handpay.
Title: Re: swaping out a s2000 printer-how to remove? Post by: vegasbaby on March 24, 2011, 02:12:21 AM Yes that part of problem,my hopper is not set to zero to force hand pay.Can i change that limit without the key chip?iM kinda stuck in between here,i can order new printer,but just want to use the machine while the printer is down.
Title: Re: swaping out a s2000 printer-how to remove? Post by: Foster on March 24, 2011, 02:27:47 AM Did you check and make sure the printer harness from the machine is plugged into the printer harness.
Are you getting Printer door open errors on the VFD when you insert or remove the printer? If printer is next to the reels. look just below the printer chassis for two screws undo them and you can gain access to the back of the printer. If the printer is in the top box there are 3 nuts to remove. You should have a short harness plugged into it that has a 8 pin connector that the machine harness plugs into. the 3 pin connection is not used so do not worry about it. Title: Re: swaping out a s2000 printer-how to remove? Post by: Buzz on March 24, 2011, 04:34:37 AM Yes that part of problem,my hopper is not set to zero to force hand pay.Can i change that limit without the key chip?iM kinda stuck in between here,i can order new printer,but just want to use the machine while the printer is down. You can do a clear and key and use the machine without ever installing a printer. Think about it, if you have coin handling why do you need a printer. Set the hopper for 50 coin pay and the rest to hand pay. yes you can set the limits without being in key menu, but only if you have NO credits on the machine. |