|
Title: reel alignment Post by: junkman on April 12, 2011, 09:00:01 AM How do you set the pay out to the reel alignment. Or set the reels to match the payout. How do you check this. My reels hit. And it pays wrong amount every once in awhile. Or how do you reset the reel strips what do I look for is there a mark to start from when putting on thge strips. I replaced the strips. When I started I marked with a pin where the old ones started and started the new ones there and went from smallest to biggest number left to right can someone help please.
Title: Re: reel alignment Post by: stormrider on April 12, 2011, 09:16:19 AM How do you set the pay out to the reel alignment. Or set the reels to match the payout. How do you check this. My reels hit. And it pays wrong amount every once in awhile. Or how do you reset the reel strips what do I look for is there a mark to start from when putting on thge strips. I replaced the strips. When I started I marked with a pin where the old ones started and started the new ones there and went from smallest to biggest number left to right can someone help please. It might help if you post what type of machine and game theme you are talking about. Tim Title: Re: reel alignment Post by: junkman on April 12, 2011, 09:18:22 AM I'm sorry its a bally e2000. Sorry
Title: Re: reel alignment Post by: morning_glory21 on April 13, 2011, 02:43:47 AM most reels have a notch on both sides that match a small peg on each side of the reel basket i think? not 100% sure though; i'm sure someone with a bally e2000 will chime in! :50- could also be incorrect software for pay table glass :151-
Title: Re: reel alignment Post by: junkman on April 13, 2011, 08:31:38 AM This one does not have notch to slide the reel strips into. When I took the old ones off I marked where they started on the reel and started the new ones there. But now I think the old ones where put on wrong by the person I bought the machine from. I just need to find out where the right stating point is on the reels so I can adjust them. The software seems to be right. Thanks
|