|
Title: DBV 200 SS IDO22/23 Troubles Post by: Neonkiss on April 12, 2011, 11:50:41 PM I have a box of the bill validators and all are marked that they were repaired or tested about 3 years ago.
None of them work. They will pass all test functions and will calibrate good, but after being set back to all dips off they won't respond. I can install a known good one in the same machine and it works great. When power is applied they won't cycle but in test mode they cycle and operate fine. I find it hard to believe that a full box of them is bad and all do the same thing. Since I don't have much hair left, I'm open to suggestions before I have to shave what's left. :257- PS can someone verify that the file DBV-200-SS IDO23 V2.60 is a cksm of 65BE Title: Re: DBV 200 SS IDO22/23 Troubles Post by: poppo on April 13, 2011, 12:10:17 AM PS can someone verify that the file DBV-200-SS IDO23 V2.60 is a cksm of 65BE Yes it is. Title: Re: DBV 200 SS IDO22/23 Troubles Post by: Neonkiss on April 13, 2011, 12:30:13 AM Thanks,
The only other thing I could think of was corrupt data, but you just verified that's not it. Title: Re: DBV 200 SS IDO22/23 Troubles Post by: poppo on April 13, 2011, 12:41:15 AM If these have been sitting for a while, you may want to try flipping the DIP switches back and forth a few times. Maybe one is stuck on. The fact it won't cycle on power up is odd unless maybe it's not in the correct mode. Just a WAG.
|