|
Title: Bally 785 D Belly glass WTB Post by: himax on May 15, 2011, 01:19:06 PM Looking for the belly glass. Any tips?
Title: Re: Bally 785 D Belly glass WTB Post by: Amachanic on May 15, 2011, 01:57:06 PM Does this machine have a belly glass now? Looks like it would take the one thats says Bally done in Black and Gold... I have seen them on Ebay...
Title: Re: Bally 785 D Belly glass WTB Post by: himax on May 15, 2011, 03:35:23 PM Here's a picture of the broken glass.
Measures 15 1/4" x 8". I have another belly glass in it now. Title: Re: Bally 785 D Belly glass WTB Post by: Amachanic on May 15, 2011, 05:07:36 PM That's going to be a tough find :99-. Maybe someone here can help or at least point you in the right direction... Good luck
Title: Re: Bally 785 D Belly glass WTB Post by: prarire on May 17, 2011, 01:22:11 AM Hello,
I need help!. Could you tell me the best way to replace the belly glass?. Do I have to take out the bottom trim piece, like whats below the reel glass. Guess, I'm lost on how to do this. Frank Title: Re: Bally 785 D Belly glass WTB Post by: Amachanic on May 17, 2011, 01:46:09 AM Hello, I need help!. Could you tell me the best way to replace the belly glass?. Do I have to take out the bottom trim piece, like whats below the reel glass. Guess, I'm lost on how to do this. Frank There are 2 screws on the inside of the door that hold the glass trim piece in place. Remove them and the belly glass assembly should pull free from the outside of the door. The screws are located near the top corners of the belly glass... Title: Re: Bally 785 D Belly glass WTB Post by: prarire on May 17, 2011, 01:51:31 AM Thank you, I will let you know how I do.
Frank Title: Re: Bally 785 D Belly glass WTB Post by: prarire on May 17, 2011, 09:16:09 PM Thank you for your Help !. I got it finally after three hours prior to your help.
Frank :259- Title: Re: Bally 785 D Belly glass WTB Post by: Amachanic on May 18, 2011, 12:03:35 AM Glad to help when and where I can...
Title: Re: Bally 785 D Belly glass WTB Post by: Op-Bell on May 19, 2011, 05:59:02 AM There is a kind of ultra-violet setting super glue that works for glass. Use it on a fine day. Lay the glass clear side up, paint down, on a stiff board, apply the glue to one of the broken edges, then push them together and expose it to bright sunlight for a minute or two. If you line it up right and hold the broken edges tight together it's hard to see the crack afterward. Clean up any glue left on the face with a razor blade and touch up the back with black paint. I've repaired pinball back glasses that way and never had one fail, and they get a lot of shaking and abuse.
|