|
Title: ChamIII (3) Starting from scratch Post by: Magicslots on May 21, 2011, 07:15:07 PM Well I bought a Cham III in hopes of installing it in the player tracking area of one of my machines...either an S2K or S+, but
I need info as to wiring harness, hookup, etc. Since it is supposed to be all self contained, I believe it needs only a power harness and a pulse connection. All I have is the display itself, no wiring etc.. :103- :103- Anybody got a Cham3 manual etc????? Title: Re: ChamIII (3) Starting from scratch Post by: stayouttadabunker on May 21, 2011, 11:38:44 PM Here you go Magic! :172-
Title: Re: ChamIII (3) Starting from scratch Post by: Magicslots on May 23, 2011, 12:20:58 PM Bunker.... :131- :131- :131- :131- Thanks for the help
Still like to hear from anyone else that has put one of these in an IGT..... :103- :103- Title: Re: ChamIII (3) Starting from scratch Post by: Foster on May 24, 2011, 09:00:13 PM I have setup the Cham II+ to a IGT S+ and S2000 so it should not be any different.
Send me the docs and I can look them over and give you advice on configuring the slot and the Cham III Title: Re: ChamIII (3) Starting from scratch Post by: stayouttadabunker on June 02, 2011, 01:23:21 PM Below is a photo of Magic's CHAMIII.
I cannot remember if it needs to be hooked up to a CON2 via the 6-pin header? Or is that 6-pin header somehow harness configured into a 10-pin connector header onto the Netplex Power Distribution board up in the top box of an S2000? :128- I've also attached an old video of me fooling around with it but I know I never programmed it or hooked it up to anything other than a 5Vdc wallwarts Power Supply pack. I've never uploaded it to the stayouttadabunker2 youtube account I've created before. I don't think there's any sound...I was just fooling around with it at the time. I did it just to document what it does really,... in testing mode... :79- What was cool about it is that it is a very compact system - a much smaller footprint than a CHAMII or CHAMII+ in a topbox area. but I believe it needed to be hooked up to a CON2 and not too many guys have them. I remember paying around $200 bucks for a CON2 - not cheap! lol It's far better economical route to go with the Netplex displays for the S2000. I'd hate to make him a communication harness for it if he doesn't own a CON2 ( if that's needed?) or does a modified/jumpered serial connector header on the unit go to the PSP program directly ? I think I have to dig around for it again and see if it does or not... :79->>> http://www.youtube.com/v/JRk4hRLKO6g?hl=en&fs=1 (http://www.youtube.com/v/JRk4hRLKO6g?hl=en&fs=1) Title: Re: ChamIII (3) Starting from scratch Post by: brichter on June 05, 2011, 10:06:33 PM I had a line on buying one of those a while back, but the deal fell through. Still looking...
|