|
Title: 14 serial pin to RS232 adapter Post by: JonaMX on May 25, 2011, 08:36:59 PM I'm trying to connect a William 550 to my RS232 built-in PC port using the SAS program, but I don't know how to build the wire the William use a 14 pin conector like the pic, anyone know what is the configuration?
Title: Re: 14 serial pin to RS232 adapter Post by: Foster on May 25, 2011, 11:25:22 PM IF you have a schematic that would help
Basically you would wire it this way I will leave machine pin numbers out for now since I do not have a schematic for the board that would connect to in the WMS 360/550 Machine PC TX -------------> 2 RX RX <------------- 3 TX GND ------------- 5 GND Title: Re: 14 serial pin to RS232 adapter Post by: JonaMX on May 26, 2011, 12:35:22 AM IF you have a schematic that would help Basically you would wire it this way I will leave machine pin numbers out for now since I do not have a schematic for the board that would connect to in the WMS 360/550 Machine PC TX -------------> 2 RX RX <------------- 3 TX GND ------------- 5 GND That's the problem I don't have any service manual or the interface schema of the Williams 550 Title: Re: 14 serial pin to RS232 adapter Post by: futkorn on March 30, 2012, 12:23:24 PM Good day,
configuration is like file attached. Pins in WMS 550 backplane. Connect RX - TX, TX - RX, GND - GND Title: Re: 14 serial pin to RS232 adapter Post by: JonaMX on May 15, 2012, 02:43:02 PM Good day, configuration is like file attached. Pins in WMS 550 backplane. Connect RX - TX, TX - RX, GND - GND Thanks futkon, I've got the schema about 4 months ago, anyway thanks! |