|
Title: S-Plus Machine - Need a schmatic for the Arm assembly! Help!! Post by: cnc74 on December 21, 2011, 07:01:52 PM :99-
I was refurbishing my newly aquired Cats N Dogs IGT S-Plus slot machine and had to take the arm assembly off to laminate the right side of the machine but some parts (mostly washers) fell out of the "pull arm controller" and I need to figure out there proper placement for reassembling it. I have the main assembly, two fat washers, one waved washer, one "C clip", one skinny washer, one very skinny washer, and one plate with several nitches-holes-and bends. Is there a breakout schematic of the arm assembly? Pictures? Anything that might help? :5- Title: Re: S-Plus Machine - Need a schmatic for the Arm assembly! Help!! Post by: stayouttadabunker on December 21, 2011, 08:01:13 PM There is a breakout drawing on page 5-116 of the S+ Field Service Manual with Embedded BA...>>>
Title: Re: S-Plus Machine - Need a schmatic for the Arm assembly! Help!! Post by: cnc74 on December 21, 2011, 08:14:39 PM Thnaks for the drawing! Much apreciated!!!
While the pic that was provided is a great baseline for reference I am looking for something with much more detail of the "inards" bottom plate assembly. Is that photo the one one in the service manual that pertains to the pull arm mechanisism parts? :99- Title: Re: S-Plus Machine - Need a schmatic for the Arm assembly! Help!! Post by: poppo on December 21, 2011, 08:45:00 PM ...I am looking for something with much more detail of the "inards" bottom plate assembly. Is this what you need? Title: Re: S-Plus Machine - Need a schmatic for the Arm assembly! Help!! Post by: stayouttadabunker on December 21, 2011, 11:23:42 PM Good post Poppo!
It MUST be Christmas around here! :72- Title: Re: S-Plus Machine - Need a schmatic for the Arm assembly! Help!! Post by: cnc74 on December 22, 2011, 01:03:28 AM Exactly!
Thanks! :131- :131- Happy Holidays! |