|
Title: Bally 6000 party spin problem Post by: slots4home on January 01, 2012, 06:29:53 PM I had to replace the processing board on a party spin and now the top wheel continues to keep spinning all the time.
Has anyone ellse had this happen? Title: Re: Bally 6000 party spin problem Post by: lindam1 on January 01, 2012, 09:07:22 PM Did you put the little plug back in on the front left of the MPU
Title: Re: Bally 6000 party spin problem Post by: slots4home on January 01, 2012, 09:34:56 PM yes I did
Title: Re: Bally 6000 party spin problem Post by: kibble on January 01, 2012, 09:43:18 PM I had this same problem with my 6000 and it was that on DS1 SW 5 needed to be off if I remembered correctly
Title: Re: Bally 6000 party spin problem Post by: slots4home on January 01, 2012, 10:52:14 PM I think you're on the right track.
could someone give me the dip switch settings for this machine for 25 cents Title: Re: Bally 6000 party spin problem Post by: coorslight115 on January 01, 2012, 11:31:10 PM I think you're on the right track. could someone give me the dip switch settings for this machine for 25 cents DIP Switch DS1 (SW1, SW2 and SW5 Secondary Device Protocol) System SW4 SW5 SW6 Anchor 1.6 OFF ON ON Bally Secondary Game(BSG) OFF ON OFF Secondary Device (SED)1 ON OFF ON 1Requires wheel control chip. Title: Re: Bally 6000 party spin problem Post by: slots4home on January 02, 2012, 12:22:33 AM thank you so very much
Title: Re: Bally 6000 party spin problem Post by: slots4home on January 15, 2012, 09:38:48 PM Well i am still working on this headache and bottom line is the top wheel does not spin at all.
The machine plays until you get the spin and ending up with a 90 communication problem. Could it be the controller board? if yes where can i find one? |