|
Title: Bally E1000/2000 Reel reader control cards. Post by: litterbox99 on February 12, 2012, 12:44:43 AM I'm trying to diagnose an E2000 slot that's giving me a
41 -2 error on reel card one. I've swapped a know working card to the same position and the issue still exists. In order to eliminate the reel reader control PCB, can I swap the controller board out with one that has DIP switches ? This one does not have DIP's. Are the controllers interchangeable ? Title: Re: Bally E1000/2000 Reel reader control cards. Post by: dhellis on September 22, 2012, 11:15:36 PM I'm trying to diagnose an E2000 slot that's giving me a 41 -2 error on reel card one. I've swapped a know working card to the same position and the issue still exists. In order to eliminate the reel reader control PCB, can I swap the controller board out with one that has DIP switches ? This one does not have DIP's. Are the controllers interchangeable ? If I am not mistaken, the reader card that includes the dip switches only has two cables that attach to it, the other one has 3 cables that attach Are your sure that the replacement card is good? I would split the card and then view the infrared transistors and see if the are illuminated. If not then your card might be bad. Title: Re: Bally E1000/2000 Reel reader control cards. Post by: tkrozleski on September 25, 2012, 10:44:25 PM You have adjusted the reader about 1/16" from the reel? Maybe the connector to the reader has a bad connection? Maybe leave the readers where they are swap the wire connecctors and see if the problem follows the the connector?
|