|
Title: Bally Blazing 7s $ Post by: Spinage on February 27, 2012, 08:22:00 PM Hello,
Received my reset chips and new tested battery. Installed them both, did a full clear, worked great. Credits showed a 5.1 then 88 2 - turned machine a noticed the reset light blinking on the MPU. Turn power off, turn back on same thing. Try and do a clear or full clear nothing happens now no CH P or CL C, nothing but a blinking reset light. Holding down the reset button, makes it go away untill you release, then your back to the reset blinkies. I have looked to see if any of the MPU back plane pins were bent and they are not. I would greatly appreciate any help on this. Thanks, Bill Title: Re: Bally Blazing 7s $ Post by: b5srt on February 27, 2012, 09:57:03 PM You need to do a complete clear......make sure you have your clear chips in the right sockets and in the right direction. Hold down the test & pseudo buttons when you turn the machine back on.
Title: Re: Bally Blazing 7s $ Post by: AffordableSlots on March 01, 2012, 03:25:50 AM Sounds like you have a bad transformer, Some of mine have done the same thing. I swapped them out and they work fine now. try putting the mpu board in another machine and ram clear it there, if it works then the other machine had a bad transformer or power supply.
|