|
Title: S+ WBA setup question Post by: AffordableSlots on February 29, 2012, 04:41:38 AM I posted this under s+ machine questions... I think this question belongs here.... :103-
I got an s+ machine that had a WBA 10 in it. It powers on and does the normal cycle, but it won't take bills. I tried and tried to make it work with no success. I know if you change a transport in an s2000 it tells you there is a crc mismatch, and you open and close the door to clear it. How do you make an s+ recognize a WBA so it will work? I am thinking it must have to communicate with it and match it to the machine somehow... But how? I already did the set chip and made sure it was set to 9-1. What now? Thanks, Bryan Title: Re: S+ WBA setup question Post by: kondy73 on March 01, 2012, 05:22:34 AM WBA-1X is something like WBA-2X and therefore I think that also communicates serial. If your WBA is not connected to thy board computer RS232 serial cable (PC COM connector canon 9pin/25pin), then I need to test the calibration set from the JCM product with the interface "MIB 232". And software "host simulator" in oficial web JCM - "support" download this program and service manual WBA. This program installs on your PC and keep complete test comunication and error mesages WBA, settings bill acceptance and banknote and stacker.
Title: Re: S+ WBA setup question Post by: brianfink on March 22, 2012, 12:49:57 AM Seting to 9-1 is all you have to do to enable a bill exceptor on an s+ check the program version the IDO for s+ should be IDO22/23 s2000 is IDO24 and wont work on an s+.
Title: Re: S+ WBA setup question Post by: AffordableSlots on March 24, 2012, 05:22:27 AM I set the 9-1 with the denomination set chip already...humm
Title: Re: S+ WBA setup question Post by: AffordableSlots on March 24, 2012, 05:26:25 AM :91- wait a minute... Do I need a RS 232 board for it to work?
Title: Re: S+ WBA setup question Post by: JCM Tech on March 29, 2012, 04:10:07 PM For IGT you do not need the RS-232. IGT uses netplex so if you have the proper software you should be all set.
Title: Re: S+ WBA setup question Post by: BR549 Auto Sales on March 29, 2012, 06:37:07 PM Not to hijack your thread here but I have a similar problem with an S + machine. I replaced the power supply for the bill acceptor, now it will cycle like it should when I power the machine on, but the bill bezel will not light up nor will it attempt tp take a bill in. I had used a set chip to enable my bill acceptor before I changed the power supply, would I need to use the set chip again since I changed the power supply? If it matters I am using a WBA 12 (transport and head)
Thanks, David Title: Re: S+ WBA setup question Post by: AffordableSlots on March 31, 2012, 05:22:46 AM If you just changed the power supply you don't need to Cody chip the mpu again. I just solved the issue I had... Make sure you are using an ido 22/23 in the WBA 12. Ido 24 will not work.
|