|
Title: was doing changeing bulbs till i broke the plastic off the buttons Post by: staz on May 30, 2012, 03:13:52 AM i was working on my machine and i never realized what a pain in the but it is to change bulbs on the button panel..... 2 out of 5 buttons broke the plastic on the sides of them...... now i need a reel spin and a service button...... i did put a century bezel on my mei that was pretty easy..... only other downfall i had besides the buttons was the harness with resisters worked to kill the buzzing engine noise but it also killed the volume of my slot had to put it to 10 to barely here it and it sounded like it was on mono mode...... so i think im gonna go with a 504b board..... heres a vid of the bezel looks pretty cool.....
http://www.youtube.com/watch?v=5BAqzsp4FeY (http://www.youtube.com/watch?v=5BAqzsp4FeY) Title: Re: was doing changeing bulbs till i broke the plastic off the buttons Post by: Foster on May 30, 2012, 03:54:52 AM Staz
Where you prying the lenses off the top to get to the bulbs? if you where that is the hard way to do it. From inside just pull down on each switch/lamp assembly Open the belly door to gain access to small buttons on the left side of the door. Title: Re: was doing changeing bulbs till i broke the plastic off the buttons Post by: cowboygames on May 30, 2012, 09:14:24 AM What size resistors did you use Staz?
Title: Re: was doing changeing bulbs till i broke the plastic off the buttons Post by: staz on May 30, 2012, 10:02:57 AM Staz Where you prying the lenses off the top to get to the bulbs? if you where that is the hard way to do it. From inside just pull down on each switch/lamp assembly Open the belly door to gain access to small buttons on the left side of the door. as i was pulling down on a couple of the button bulb harnesses the black plastic that holds the bulb harness into place broke off..... Title: Re: was doing changeing bulbs till i broke the plastic off the buttons Post by: staz on May 30, 2012, 10:05:30 AM What size resistors did you use Staz? dont no the size resisters i didnt make the harness but i think changing to a 504b board should solve the issue?????????? Title: Re: was doing changeing bulbs till i broke the plastic off the buttons Post by: cowboygames on May 30, 2012, 10:31:09 AM It should, but you'll need to get rod of that harness with the resistors on it when you do.Using a 45 ohm or smaller resistor should fix the problem and not affect overall volume very much
|