|
Title: touch screen Post by: kyalo on July 17, 2012, 12:32:49 PM what could be the course of touch screen not sensing at the exact point even after calibration. :103-
Title: Re: touch screen Post by: cowboygames on July 17, 2012, 01:12:32 PM Does the machine indicate it's saving changes at the end of tha cal? Or does it give an option to save the changes at the end of the cal?
Title: Re: touch screen Post by: kondy73 on July 28, 2012, 06:07:06 PM what could be the course of touch screen not sensing at the exact point even after calibration. :103- You did not say what type you use a touchscreen. Title: Re: touch screen Post by: kyalo on August 02, 2012, 07:28:51 AM @ kondy73 - type, microtouch3M mostly on ceronix monitors and i game igt machines or atronix machines
@cowboygames - no saving on igt i games just calibration ,touch the the dot then takes its time the tells you to close the door to finish the process. Title: Re: touch screen Post by: Djaewolf on October 04, 2013, 05:43:49 AM I have this same problem all the time on my igt monitors that use 3m microtouch. Luckily all I've had to do for most of them is just disconnect and reconnect the connections on the touch controller board. if that doesn't work check your touch sensor for damage
Title: Re: touch screen Post by: channelmaniac on October 04, 2013, 02:40:31 PM Check around the edges of the screen to make sure the bezels aren't pushing on the touchscreen overlay.
|