|
Title: Bally 6000 - code 54 Post by: FORDSBS on August 31, 2012, 01:25:17 PM Ran into a new one. Putting a 6000 together. Set up OK. Code 54 comes up -drop door open.
I could not get rid of it - Put in another mpu with same chips & no more code. I put chips back in 1st board & same code 54. Put other board in & all works OK. It has to be in board I got. Used same chips so it's not them. Any advice ? Thanks Ford Title: Re: Bally 6000 - code 54 Post by: a69mopar on August 31, 2012, 01:57:19 PM check connectors at backplane, if ok, check harness..
w Title: Re: Bally 6000 - code 54 Post by: coorslight115 on August 31, 2012, 02:18:50 PM Ran into a new one. Putting a 6000 together. Set up OK. Code 54 comes up -drop door open. I could not get rid of it - Put in another mpu with same chips & no more code. I put chips back in 1st board & same code 54. Put other board in & all works OK. It has to be in board I got. Used same chips so it's not them. Any advice ? Thanks Ford Are all of the dip switches set the same. Not near a manual right now but I thought there was a dip switch for drop door optics. Title: Re: Bally 6000 - code 54 Post by: FORDSBS on August 31, 2012, 02:28:00 PM Thanks guys. I'm sure it's in the board. Over weekend I'll have to go over everything again .
Title: Re: Bally 6000 - code 54 Post by: Red7 on September 04, 2012, 02:29:12 PM Double check the board didn't have a bent pin, or a broken off pin.. they are hard to see sometimes
|