|
Title: Troubleshooting 11's 12's and 13's Post by: Abe Frohman on September 02, 2012, 09:05:07 PM Hello all,
I purchased a truckload of "parts complete" Bally and IGT slots. About half of them came with bill validators. I have ten Bally ProSlot 6000's and out of all the bill validators, only *one* worked with the 6000's. I've probably put every validator into every unit, and all the same result - one works in all the Bally's, the rest do not. It's a 13 and it has a label on a ROM underneath showing a program revision. The rest are composed of two 13's which seem to be missing the ROM, and then a small pile of WBA 12's which, I'm assuming, have the wrong programming on them and need to be flashed. Is that probably what I've got here, would you think? A bunch of 12's that probably just have the wrong programming? They spin and whirr on power-up but the do-not-enter light goes on shortly after the green arrows and it won't even taste a bill to see if it likes it. I suppose I might have to ship the whole lot of 'em to someone who can clean these up for me or something. I was hoping out of the twenty-some units I was going to have enough parts to tell the good from the bad, but I ended up with two IGT's and only one Bally working, which doesn't really help me troubleshoot all that much. Thanks for any guidance... Title: Re: Troubleshooting 11's 12's and 13's Post by: kurthorton45 on August 16, 2013, 01:29:25 AM I have a 12 and mine makes the noise but only trys to accept 1 bill then spits it out then nothing. How do i see what machine i have to do more research?
|