New Life Games Tech Forums

My slot stopped working about a month ago. It was working then it stopped. The lights come on but nothing else. I keep reading POWER SUPPLY issues are common. Any suggestion on how to test and where to purchase? Many thanks in advance

Blueridgeslots had the power supplies.  you can check for voltages with a meter.  they were a weak link on the earlier machines.

you should fill out your profile so that people will know what area of the world you are in..  you may have a neighbour that has the parts.

thanks,
Wayne

Wayne,

Thanks for your response! I looking for a schematic but have not had any luck. I also updated my profile. Again thank you for your help.
Jonathan

I think raz410 has them also

UPDATE: Purchased Power Supply from Rudy's Deals and installed today. I think the power supply is either damaged or incorrect the light on the mpu board is very dim and the hopper is pulsating. If I push the hopper buttom the green and the red work but no displays. Any suggestions? I am about to pull what little hair I have left out.

Jonathan,
Here's a link to a manual. Check out the other goodies here also!

http://slot-tech.com/interesting_stuff/bally/ProSlot/ (http://slot-tech.com/interesting_stuff/bally/ProSlot/)

Barry

Barry,
Thanks Alot!

Update - Contacted Rudy's Deals - Going to send out another power supply - GREAT CUSTOMER SERVICE!!!!!!!!!!!!!!!!!!!!!

I am determined to fix this. To everyone that is responding....THANK YOU!

I am going to write a book... " Slots For Dummies" LOL

Update: Rudy's sent another power supply. Thanks again for the great customer service!!! Now everything powers up and if you guess I got codes you are correct. One is 5.0 which is door switch and other is 7.3 reel movement. I have check the wiring am I am sure that I am not missing anything and the switches are good. Any suggestions? I am almost bald.

Thanks in advance

Clear machine

HE'S CORRECT

Thank you for the response. How do I clear the machine. Sorry I am the "FNG"!

You need U28 & U43 clear chips

Where can I get U28 & U43 clear chips?

jj slots had some
http://jjslots.com/

I never had to clear the machine to get rid of the 73 error.. open the door and hold the change switch and shut the door.the reels well realign and should clear the 73. open and shut the door again and that should clear the 50.. hope this helps tried sending this from my cellphone

That's worth a try

I would also check the reel harness to the backplane
 make sure it's fully seated.. since you change the power supply you might have jarred something loose

funtime1, did you get it working?
Did you try what stormrider told you?

Hi Funtime1, can you send me a picture of your MPU? Maybe I can help you to clear the machine without clear chips.

change 3-4-12-15  to 920000 you never need clears again just a jumper check and see the series on those chips

Update: Thanks to everyone for their help! I had to go out of town but I am planning on working on it this weekend. So everyone keep their fingers crossed!

Update - I did a partial reset and it cleared the code 73 but 50 was still present. I rechecked all door switches and found the blade switch on the top door not was not closing the circuit properly so I replaced it and NOW IT IS FIXED!!!!!!!!!!!!!!!

Thanks again for everyone advise and words of encouragement!

Good too see you fixed it good luck   Paul

Thanks Paul !