|
Title: igt m cam followers Post by: wilkey1300 on December 08, 2012, 09:41:44 PM Does anyone know of a source for for the cam follower wheels?
Thanks in advance. Title: Re: igt m cam followers Post by: Joeylc on December 08, 2012, 10:01:39 PM can we get a pic of the game ???
Title: Re: igt m cam followers Post by: blueridgeslots on December 08, 2012, 10:13:01 PM Use Bearings, 1/4" wide 14" ID 3/4" OD there was just a post yesterday about these and if you search above there is an old post with website and part number with them available
Title: Re: igt m cam followers Post by: wilkey1300 on December 09, 2012, 06:43:06 AM Thanks for the info. Here is a pic.
Title: Re: igt m cam followers Post by: blueridgeslots on December 09, 2012, 10:42:34 AM Here is the info from previous post by Tilt
My reel kickers cork rollers were shot too. I couldn't find any nylon rollers to replace them with. I ended up putting ball bearing in their place. They are 1/4" X 3/4" X 1/4" and the only place I found them was a company called mscdirect.com. Item # 01376748. It cost about $10.00 + shipping for all three. http://newlifegames.net/nlg/index.php?topic=2374.msg33645#msg33645 Title: Re: igt m cam followers Post by: proten on December 09, 2012, 01:53:25 PM Do they have to be 1/4 " wide?
There a bearing supplier that has a close size if 1/32 larger is ok (1/4" x 3/4" x 9/32") and are only $1.95 each. http://www.vxb.com/page/bearings/PROD/R4AZZ-1 (http://www.vxb.com/page/bearings/PROD/R4AZZ-1) Title: Re: igt m cam followers Post by: Neonkiss on December 09, 2012, 03:59:21 PM The only difference would be if you will be able to install the E-clip to hold them on?
I don't remember how much play there is with the 1/4 inch wide bearing. Check your shaft and measure the distance to the grove for that E-clip. Title: Re: igt m cam followers Post by: wilkey1300 on December 09, 2012, 10:38:37 PM Does anyone know where I can get a M series service manual? Thanks in advance.
Thanks to cliff for the email copy. |