|
Title: Wells Gardner D9410 in a Big Buck Hunter Post by: fozman on January 10, 2013, 07:33:58 PM Cant seem to find much for help on this 27" digital monitor. Its dead, fuse good, checked all caps, and replaced a couple that were just questionable. If any one can help i would be grateful.
Title: Re: Wells Gardner D9410 in a Big Buck Hunter Post by: montech on January 13, 2013, 06:22:55 PM Hello
I have found that these were soldered with lead free solder and thus have multiple cold solder joints in them. You can repair with 60/40 as lead free requires higher temps.You can download the print from WG and get a starting point. Is the switched mode running, horz drive etc. Title: Re: Wells Gardner D9410 in a Big Buck Hunter Post by: fozman on January 15, 2013, 06:11:27 PM Thanks, I will have another look. Horiz. is fine. I was kinda wondering if I had a bad reg. in PS
|