|
Title: GAMEMAKER HOPPERS - WHAT TYPE? Post by: FOXSSLOTS1 on February 19, 2013, 07:06:06 PM I have several Bally Hoppers that at one time worked in Pro series pokers and slots - they do not work in my Gamemaker - I get a hopper jam error - diagnostic says PROBE HOPPER EMPTY. is there a wire difference?
Title: Re: GAMEMAKER HOPPERS - WHAT TYPE? Post by: Jim on February 20, 2013, 03:47:30 PM I think they both used the standard XS1200 model hopper.
I compared the 5500 and the 7200 upright wiring and both are identical, so in theory they should work. pin 1= or/ye door switch pin 2= rd/ye fwd sense pin 3= rd/gn fwd enable pin 4= rd/wt f/r pin 5= rd/blk rev enable pin 6= ye coin out pin 7= bl/orn coin probe pin 8= ye/bl +24vdc pin 10=gy/blk 24v gnd pin 11=gy/orn 24v gnd pin12 = or/wht hopper reset pin13= ye/bl +24vdc pin 14= bl/ye fill switch pin 19= chassis gnd Jim Title: Re: GAMEMAKER HOPPERS - WHAT TYPE? Post by: FOXSSLOTS1 on February 20, 2013, 06:34:44 PM thanks jim - the diff seems to be on the control board - the gamemaker uses the 339 dual optics - the pro uses 171. I have chased down the PROBE wiring and it goes to gnd and to the backplane - so could it be in the CPU? The message I get HOPPER JAM - diagnostic says "HOPPER BOWL SWITCH - NOT FULL" since the probe only goes to gnd and to the backplane - does not pass thru control board.
|