|
Title: Thread size for cash box housing Post by: wireless73 on February 26, 2013, 05:58:02 PM Curious to know if anyone has a list of screw sizes for the various S2000 components they could share. I don't own a thread checker and am looking for the screw size used to mount the cash box housing (item #2 in pic). I didn't see this specific screw size entry in the a parts components list I have. I know it is a flat head vs. the normal pan phillips a lot of the other components use. Its awful without the screws in place, every time I pull the cash box I about take the housing with it.
Thank you. Title: Re: Thread size for cash box housing Post by: Foster on February 26, 2013, 09:50:45 PM I am not sure of the sizes but I have 2 pan heads on the left side about along the shelf for the transport (JCM WBA) and 2 smaller ones at back where the cash can goes.
Title: Re: Thread size for cash box housing Post by: Buzz on February 26, 2013, 10:21:26 PM Just remove one of each size out of one of your other machines, go down to a hardware store and match them up. Pretty good guess is that they are metric thread.
Title: Re: Thread size for cash box housing Post by: wireless73 on February 26, 2013, 11:31:29 PM Ya I guess I'll have to. I am putting an order in at mcmaster.com and was hoping to throw these in with it. I threw some in the side for now. If anyone needs to know the side screws I used were metric pan head phillips machine screws with an external-tooth washer, M4 Sz, 8mm L, .7mm Pitch. Thanks all
Title: Re: Thread size for cash box housing Post by: Buzz on February 27, 2013, 03:35:37 AM IF any of your machines still have the cherry switch in back of the cash can, remove it and use those screws to hold the chassis in. ( Same size screws ) If you look I'll bet no wires are going to the cherry switch.
|