|
Title: I-game 12volt bulb strip above Bill Validator out Post by: teamclark4 on March 15, 2013, 03:14:07 AM Was working fine; turned machine back on today and all 5 lights are out. No 12v to the strip.. This is the 12 inch tall x 3 inch wide (approx) yellow down arrow pointing at the BV that says that it takes 100, 50 etc.....
Maybe a fuse ? Or do i have a crapped board now. I have switched the door i/o and the 2 i/o boards above power supply with a known good one and nothing.. Any thoughts ? Thanks :131- :131- Title: Re: I-game 12volt bulb strip above Bill Validator out Post by: Tilt on March 15, 2013, 11:11:06 PM The door I/O board supplies the +13VDC to light the 5 lamp panel. There isn't a fuse on the lamp panel. If you don't have +13VDC power going to it, trace the wires back to the IO board connector and see if you have it there. It should be a red and red with black tracer wire.
Title: Re: I-game 12volt bulb strip above Bill Validator out Post by: teamclark4 on March 16, 2013, 02:36:08 AM Thanks for the reply... The first thing i did was swap the door i/o board from my "good" igame and put it in the "bad" one. Then i took a light from the "good" igame and tried it in the "bad" igame and it still didn't work so i figured that wasn't it. I didn't start using my voltmeter until AFTER i ruled out the door i/o board. I probably need to revisit that. I should take the door i/o from my "bad" machine and put it in the "good" one and if the good one now doesn't light up those lights then that would confirm that it is the i/o board (maybe it was a fluke when that one light originally didn't work when i did the initial swap)..
I will try that tomorrow when i have access to the machines and let you know. Thanks |