|
Title: Need help with 60-1 jamma set up Post by: KYPinhead on April 01, 2013, 03:55:13 PM Hello all,
I'm trying to convert a Centipede upright to a 60-1. So far I have done the following: Installed & wired a 16 switching PS. Wired the jamma harness to the PS & player 1 & 2 start buttons, player 1 & 2 fire buttons & the 4 joystick switches. Plugged in PC monitor Everything is wired properly, but none of the buttons work. The game boots up properly, I just cant do anything from that point. I did put bit 4 of the DIPSW in the on position, it went into test mode, but switches still won't work. I did notice on the Icade pcb that LED 4 stays on, is that normal? I just bought this kit a week ago. Any help would be appreciated! Norman Title: Re: Need help with 60-1 jamma set up Post by: slotsteve on April 01, 2013, 08:20:42 PM sounds like a ground missing
Title: Re: Need help with 60-1 jamma set up Post by: KYPinhead on April 01, 2013, 08:27:46 PM I thought that too, but ground is good. Found out the lit LED is normal.
Norman Title: Re: Need help with 60-1 jamma set up Post by: slotsteve on April 01, 2013, 08:41:34 PM if carefull you can jump coin sw at edge conector to ground and see if it puts up a credit if it dose that means you have bad wiring
Title: Re: Need help with 60-1 jamma set up Post by: KYPinhead on April 01, 2013, 09:24:40 PM I'll give that a try tomorrow. I have a feeling the Icade is bad. Thanks.
Title: Re: Need help with 60-1 jamma set up Post by: slotsteve on April 01, 2013, 09:52:40 PM we sold over 200 60/1 board not a bad one ever
Title: Re: Need help with 60-1 jamma set up Post by: KYPinhead on April 01, 2013, 10:22:46 PM That's impressive. Probably not the board then.
Title: Re: Need help with 60-1 jamma set up Post by: BR549 Auto Sales on April 01, 2013, 11:25:26 PM Some of the jamma harnesses out there are pretty cheaply built, I have had a few bad ones over the last few months, so it could be the connector on the harness itself, at least that's where I had issues on them.
Title: Re: Need help with 60-1 jamma set up Post by: KYPinhead on April 02, 2013, 12:29:26 AM I checked the harness for continuity, actually from the board traces to the switches, checked out fine.
Title: Re: Need help with 60-1 jamma set up Post by: KYPinhead on April 02, 2013, 02:16:00 PM Problem solved! Coin 1 switch must be connected to add credits (I had coin 2 switch wired but not 1). The switches won't work without credits. Hopefully this thread will help other newbies.
Norman Title: Re: Need help with 60-1 jamma set up Post by: slotsteve on April 02, 2013, 04:05:49 PM great news
|