|
Title: Need Help setting up Bally Hot Shot Progressives Post by: Magicslots on April 01, 2013, 05:41:20 PM Thanks to others here, I found out how to get into the progressives menu via the Comm page.
My problem is that no matter what figure I set, the progressives always show as INVALID... (http://) I have cleared the machine multiple times, and no matter the numbers or the % settings...same message! :30- Title: Re: Need Help setting up Bally Hot Shot Progressives Post by: Magicslots on April 01, 2013, 05:46:59 PM I sometimes get the message after entering the data to "override current values"
This is an example of data i entered: (http://) Title: Re: Need Help setting up Bally Hot Shot Progressives Post by: Magicslots on April 01, 2013, 05:50:53 PM I enter the daat until the field turns green,, saqve and no change, still invalid....What am I missing or doing wrong?
I did find that the progressives will not enable at all if you enable multi-denoms... (http://) Title: Re: Need Help setting up Bally Hot Shot Progressives Post by: idesign on April 01, 2013, 06:08:08 PM Hot SHots is set up as follows:
20000 2000 200 100 20 Your percentages are too low. You have less than 1% for all of them. Make then all 1.25%. This is for a 1 cent machine, 20 lines Title: Re: Need Help setting up Bally Hot Shot Progressives Post by: Magicslots on April 01, 2013, 06:38:48 PM The numbers and percentages were not my choice, the owner who was putting it in a game room wanted those figure..
Is there a minimum spread required? Percentage?? Title: Re: Need Help setting up Bally Hot Shot Progressives Post by: idesign on April 01, 2013, 07:44:48 PM Yes, you can use 10000, 1000, 100, 50 and 10 too. You just can not use any numbers. If you compare to the other numbers I gave you, you can see there is a specific pattern here for them. As for percentage contribution I have mine set to 1%, 2%, 3%, 3% and 3% (high to lowest progressive)
|