|
Title: Atronic Topper Power SOLVED Post by: therockinelvis on April 10, 2013, 02:03:29 PM I've got a topper I can't quite figure the voltage on. I applied 12 vdc and the chase lights ran. It appears that the flouresents are powered by the same wires however do not light with 12vdc or 24vdc. I unplugged the chaselight so I would not blow the controller. I am now guessing that it should all be powered by 110vac. Can someone help so I don't ruin it. Here are pictures. It has a 250 volt 2 amp fuse which is why I'm guessing 110vac.
Title: Re: Atronic Topper Power Post by: therockinelvis on April 10, 2013, 02:04:32 PM Here are 2 more
Title: Re: Atronic Topper Power Post by: TZtech on April 11, 2013, 04:34:35 PM check for any markings on the ballast
Title: Re: Atronic Topper Power Post by: therockinelvis on April 11, 2013, 05:37:04 PM The ballast is surrounded by steel. I guess I could bend an end open maybe. Someone has to have an Atronic in the shop.
Title: Re: Atronic Topper Power SOLVED Post by: therockinelvis on April 11, 2013, 09:43:10 PM OK for anyone else looking. The red wire is 5vdc+ and the black wire is 5vdc- for chase lights. The green wire is 24vdc+ and the white wire is 24vdc- for the ballast. Hope this helps someone else. Happy Gaming and Thank-ya-Thank-Ya-Very-Much.
Title: Re: Atronic Topper Power SOLVED Post by: superparts on April 13, 2013, 10:41:38 AM Do you need a ballast? I have tons of atronic stuffs!
Title: Re: Atronic Topper Power SOLVED Post by: therockinelvis on April 13, 2013, 01:48:49 PM My ballast is good. I do need an IGT Marquee control Board part #7692480 to run the chase lights for an IGT topper. Here is the picture. Thanks, Jim
|