New Life Games Tech Forums

Hello All,
      My IGT S2000 Reel Touch machine has been causing me some headaches over the past week. When I turn on the machine, the machine boots all the way up almost to the game. Instead of booting completely, I get a "Main Battery Low" error and "Closure M" error which prevents the game from starting. On the reel touch screen, it says "Call Attendant". I have replaced the 3V CMOS Battery on the board, but that didn't help any. Can anyone please provide some assistance. (Pictures would also help) if providing an answer as I am not real technical when it comes to this machine. I really appreciate everyone's time!

Eric

You need to replace the 3 volt coin cell battery on the main cpu board in the bottom cabinet. Depending on weather you have the newer board or older board the battery could be soldered to the board. If you have an enhanced board it will slide out and can be replaced without soldering. Hope this helps.

I apologize for my ignorance, where might I be able to find the 3V battery in the bottom cabinet. Thank you for your time!

Eric

On the lower left hand will of the cabinet is your MPU. With the machine off pull that tray out and you'll see it

Found it. How in the heck do you get the battery out of there. Again sorry for my ignorance.

Eric

It is soldered on if it is not an enhanced board

Usually it is a br2330 or br2335 if it is not a slip in battery which is used on the enhanced board.

If you have the yellow battery it is not enhanced as in pic  and does NOT need green battery  It will be soldered in . You can solder in a holder so battery can be a slid out in the future .  If it has a slide out coin battery . it is replaceable just slid out to replace  it is enhanced as in pic. NOTE **** Enhanced boards NEED green battery to work . P.B.

I have replaced the battery as described above. Thanks for the photos Plunger Boy.

Now, once the machine starts to boot, I see the small display reading "Call Attendant". When I open the machine, I get a loud noise and screen the reads "RAM Error". Any ideas on how it fix this. Again, I appreciate everyone's assistance!

Turn the Jackpot key on the outside of the machine when you hear the loud noise with the door still open. Watch the small display and turn the jackpot key again until it tells you to hold the white button on the MPU for 3 or more seconds. Follow it's instructions.

Ron (r273)

with the door open, turn the jackpot reset key 4 times and then press the test button on the CPU for 3-4 seconds then the display should read "please close the main door" So close the door, wait for the machine to re set and then open the door, then you will get another siren/error code, then turn the jackpot reset key 3 times and close the door. After that it should be in ready to play mode. You might want to check and make sure you have your limits set before you put any money into the machine to add credits.

Thank you so much BR549 Auto Sales and r273. The machine is back up and running. I would like to thank everyone for their time and help in assisting me in getting my slot machine up and running! I really appreciate it! Have a great day!

Eric

replace the battery with a holder,  then almost any coin cell will work, i would recommend a 2325 -you can even find them at most walgreens.

I also just wanted to add my thanks for this information. I also was going through this same exact situation. Seeing that ram error and that loud alarm when I opened the door really had me worried. Now I also got my machine back up and running perfect.   :244-