|
Title: Bill acceptor lights for s2000 upright does not work Post by: rickaaaer on April 29, 2013, 09:05:04 PM I have a machine that I'm bringing back to life. It's a s2000 triple triple diamond machine. I had to replace the door harness. Its working great. I installed a bill acceptor this weekend it also works. The problem is the BV light will not work. I replaced the circut board and put in new bulbs. I don't know what else to check I need your help .
Title: Re: Bill acceptor lights for s2000 upright does not work Post by: lindam1 on April 29, 2013, 10:28:54 PM On the back of B/V where the wires are there is a 2 wire plug that controls the light. Make sure it is plugged in.
Title: Re: Bill acceptor lights for s2000 upright does not work Post by: Buzz on April 29, 2013, 11:44:02 PM I don't know why I'm going to say this, but I seem to recall if you trace the wires from the BV bezel to some where behind of the reels you will find another plug. Damn this CRS, wish I could say for sure !!
Title: Re: Bill acceptor lights for s2000 upright does not work Post by: rickaaaer on April 30, 2013, 12:11:23 AM Thanks buzz that might be it
Title: Re: Bill acceptor lights for s2000 upright does not work Post by: rickaaaer on April 30, 2013, 12:36:11 AM Found the problem. The yellow an black wires were not plugged in good. The door harness an cabinet harness yellow an black wires
Thanks |