|
Title: Belly glass Post by: sturgeongeneral on May 22, 2013, 01:55:45 AM I haven't really looked yet, but how do you change the belly glass on an S2000?
Title: Re: Belly glass Post by: cowboygames on May 22, 2013, 01:59:22 AM Lower the belly door then remove the three screws that hold the light assembly on. Glass should pop out easily after that
Title: Re: Belly glass Post by: T on May 23, 2013, 06:50:27 PM Lower the belly door then remove the three screws that hold the light assembly on. Glass should pop out easily after that Can you clarify this a little more? How do you lower the Belly Door? I am sure this is pretty easy. I just did not see it right off. Thanks Title: Re: Belly glass Post by: CVslots on May 23, 2013, 06:55:15 PM On the main door, by the lock, there is a little knob sticking out. Pull out on that little knob and the belly door will fall open.
Title: Re: Belly glass Post by: T on May 23, 2013, 10:17:00 PM On the main door, by the lock, there is a little knob sticking out. Pull out on that little knob and the belly door will fall open. Thank you. That did the trick. I was trying to Install that plasic coin diverter / light shield on the bottom of door. Opening the Belly glass door made that possible. Thanks again Title: Re: Belly glass Post by: sturgeongeneral on November 20, 2013, 06:37:32 PM I just wanted to pass on a warning. When you unlatch the belly glass door MAKE SURE that you pot your hand under the door as the weight of the door, glass, and light are VERY heavy! If you don't support the door it will drop with a bang. Luckily I didn't crack my door glass, but I wanted to post a warning. Make sure when you close the door that it fully latches also. Otherwise it will drop open with a BANG!
|