|
Title: WBA-12-SS Post by: GizTek on March 22, 2009, 10:19:28 PM Can anyone explain to me how to use a Mag Tool to calibrate a WBA12? I tried to hook it up the way that I thought it would go and the program (Adj10win) said " timeout error detected" then made me close it out.
Title: Re: WBA-12-SS Post by: JCM Tech on March 26, 2009, 07:30:14 PM The procedure for Calibrating the WBA 12 is covered in the service manual http://www.jcm-american.com/docs/manuals/960-000076.pdf. Which mag tool do you have? The origional was called an "MG-03" there is a newer version (updated electronics and much smaller) also available. http://www.jcm-american.com/docs/bulletins/bulletin-200810.pdf.
If your getting to the mag setting before it times out, you may not have any signal from the mag board detected. Give JCM tech support a call at 800-683-7248, they should be able to walk you through the procedure. Title: Re: WBA-12-SS Post by: stayouttadabunker on March 26, 2009, 11:45:09 PM Good job with the links JCM! :3-
Title: Re: WBA-12-SS Post by: GizTek on March 27, 2009, 12:28:53 AM Thanks! I'll check it out!
|