|
Title: Bally topper wiring help needed Post by: seabreeone on June 28, 2013, 02:41:04 PM Hi all, I just bought a bally topper at a antique store for 20.00, It came with no wiring harness or internal wires.( So I don't have a color code to go by) It has a back lite LED board not a fluorescent light. The board has 26 LED's part # PCA107327-x-7A. On this board it has a black female Molex connector with 4 pins. The front chaser ring has a 2 pin female molex and a 4 pin male molex connector. It looks like the power may feed to the led ring first then the back lite led board 4 pin connector?
Can anybody help me out on how I hook this up? The Voltages? or do you have a wire diagram. I will make a harness or two to the back lite LED and to the power supply. I just need to know what pins do what? and the supply voltages. Thank you in advance for any help.......Rick Title: Re: Bally topper wiring help needed Post by: Neonkiss on June 28, 2013, 06:38:17 PM I don't have a pin out, but this sounds like a topper from an Alpha machine.
Post a picture. :317- The 4 pin connector is for the candle, the two pin is the LED ring and the black 4 pin connector is for the internal LED lighting. I think that one has gray and yellow wires. I made some of these up a while back but did not keep the pinout. Title: Re: Bally topper wiring help needed Post by: seabreeone on June 29, 2013, 02:24:54 AM the 4 pin connector is very small it is not the candle plug. What were your voltages to light the back lite leds?
Title: Re: Bally topper wiring help needed Post by: Neonkiss on June 29, 2013, 10:42:59 AM Never checked the machine voltage as I was just making a new harness to match an existing.
Plugged it into my machine and all worked good. I got a group of toppers where someone cut the wire harness when the removed them from a machine. |