|
Title: Sigma 300 WBA 11 Post by: Randy0777 on March 27, 2009, 12:13:41 AM Fell like trouble shooting some tonite :25-
Have a few 300s with WBA-11 in them. When I bought the machines the housing,transport and harness where the transport slides into(the one on the housing) were missing. I installed everything and they will accept the bill,wait a few sec's and spit it out. All of the other machines have 13's so I have nothing to compair it to. If you look at the picture you can see where some of the wires were cut :103- Not sure if that is some of what I needed. Oh,the trans have the Sigma chip Title: Re: Sigma 300 WBA 11 Post by: a69mopar on March 27, 2009, 12:30:22 AM most likely a software issue, what version do you have in them? The wires are likely fine.
Good luck, Wayne Title: Re: Sigma 300 WBA 11 Post by: Randy0777 on March 27, 2009, 12:43:55 AM V3.60-30 (07FEB06) is the sticker on them.They are flashed based .
Title: Re: Sigma 300 WBA 11 Post by: a69mopar on March 27, 2009, 12:44:46 AM Oddly enough, I took a peek at the manual and only see wba 12 + 13 mentioned (as well as Mars).
W Title: Re: Sigma 300 WBA 11 Post by: Randy0777 on March 28, 2009, 03:07:55 AM I seen that also. I forgot had some some spare WBA eproms for the Sigma. I grabbed a 11 from a IGT and replaced the chip and it works fine in the Sigma :3- So your first guess was right... wrong ver on the trans :37-
Title: Re: Sigma 300 WBA 11 Post by: a69mopar on March 28, 2009, 10:01:27 AM :3- It's good to hear you got it going. I had a similar problem before where the protocol (ID) was wrong and it did similar things. You can never trust a sticker.
Thanks for letting us Know, Wayne |