|
Title: Closure B / Closure MB drives me up the wall Post by: playwitslotmachines on August 09, 2013, 11:59:19 PM Hey guys, I haven't changed the main coin battery yet, well the machine was functioning properly earlier this afternoon until I turned it on again later tonight. The whole thing keeps on getting this "Call attendant, Door open MB" on and off like several times. I noticed it after I played it and it went into general reel tilt. This is for a Cleopatra 5 reel machine.
Thanks in advance Title: Re: Closure B / Closure MB drives me up the wall Post by: playwitslotmachines on August 10, 2013, 12:14:28 AM After i noticed it was tripping out, I went back to the machine 20 minutes later and i turned it on, waited for two minutes and it's working fine, my slot machine has a mind of its own for some reason ahaahaahhhahaha.
Title: Re: Closure B / Closure MB drives me up the wall Post by: therockinelvis on August 10, 2013, 10:08:59 AM Check the GREEN Battery on your board. That starts happening from corrosion to the traces under the varta battery. If you have acid damage clean it well with vinegar. Most s2000 do not need that battery. I take them off of all my machines. I have never figured out how to repair the traces and buy new boards. Good Luck
Title: Re: Closure B / Closure MB drives me up the wall Post by: CVslots on August 10, 2013, 07:34:43 PM While you've got your board out, check your main battery as well. We've had machines go crazy when the main battery drops below 2.8v.
Title: Re: Closure B / Closure MB drives me up the wall Post by: Buzz on August 10, 2013, 08:35:29 PM Adjust your door optics.
Title: Re: Closure B / Closure MB drives me up the wall Post by: knagl on August 11, 2013, 06:29:29 PM I agree with Elvis - likely corrosion to the traces of the board under the green battery.
Title: Re: Closure B / Closure MB drives me up the wall Post by: playwitslotmachines on August 11, 2013, 06:35:28 PM I'll try cleaning it with the vinegar. Thanks guys
Title: Re: Closure B / Closure MB drives me up the wall Post by: therockinelvis on August 11, 2013, 11:44:22 PM Most likely it won't help cleaning it since it is acting up. I'm sure Roz at CVSLOTS or Rudy's Deals will have a replacement board. I would like for someone to post how to repair the traces with pictures.
Title: Re: Closure B / Closure MB drives me up the wall Post by: playwitslotmachines on August 11, 2013, 11:57:38 PM I have to buy a whole new board? shoot!!! now i'll never use my new soldering kit ahhaaaa. Anyway i turned my machine on and it's not acting up anymore thats weird
Title: Re: Closure B / Closure MB drives me up the wall Post by: cowboygames on August 12, 2013, 01:11:46 AM You can try repairing it if you. An solder in jumper wires from the first actual component on either side of the bad spot in the trace. Usually works and it's good practice
|