|
Title: I-Game Printer Post by: aplmak on September 19, 2013, 12:48:36 PM I just have a stupid question... Two of my printers print the LARGE print of my game room casino name.. The third printer I have prints it real small on the top... Is it the version of the printer or could I just get a new printer chip to change it to the larger print?
Thanks for any replies! Title: Re: I-Game Printer Post by: cowboygames on September 19, 2013, 01:34:06 PM I would think the larger print was SST up by the casino using their back end syatem
Title: Re: I-Game Printer Post by: aplmak on September 19, 2013, 01:55:19 PM I think it's in the firmware software of the printer myself.. Either that or I need a different model printer.. I have all three machines on the Bettor Slots TITO boards...
Title: Re: I-Game Printer Post by: CVslots on September 19, 2013, 01:59:03 PM Is the LARGE print printer a different printer than the others?
Title: Re: I-Game Printer Post by: rickhunter on September 19, 2013, 02:12:50 PM On my mother's bluebird machines one prints large and the other small. The one with large print is a Gen2 printer, the one with the small print is an ST66 gen1. I have not ran the same software on both machines to see if that makes a difference though.
Title: Re: I-Game Printer Post by: a69mopar on October 02, 2013, 11:02:07 PM different firmware can cause this.
W |