|
Title: Meter Disconnect Post by: montech on October 17, 2013, 09:26:24 PM Game King with 960 motherboard. Already tried the I/O card and MPU board. So I pulled the mother board but cant seem to find the schematic on this version. Plenty of 044 available.
Anyone know what pin to pin it is for meter disconnect? Thanks all . Title: Re: Meter Disconnect Post by: Tilt on October 17, 2013, 11:02:49 PM I've attached the motherboard schematic you were looking for. I'm assuming that you have a GK+ since you mentioned pulling the IO card vs the IO card tray the older GK machines have. I doubt your problem is on the motherboard though. The meter disconnect signal is an input to the IO card, and the IO card combines that with several other inputs and puts them out to the motherboard on the SENET bus. In other words there isn't a separate signal for the meter disconnect that goes directly through the IO card to the mother board and onto the MPU board. On page 4 of the document I circled the two pins on P110 that need to be jumpered either via being connected to the meter board, or if no meters are installed, a jumper. If neither one is present the IO card will report to the MPU that the meters are disconnected via the SENET bus.
Hope this helps. Title: Re: Meter Disconnect Post by: montech on October 18, 2013, 12:06:41 AM Thanks so much Tilt. Handy info.
:3- It turned out to be the Power Supply. Go Figure. Title: Re: Meter Disconnect Post by: Tilt on October 18, 2013, 12:23:19 AM Anytime. Glad you got it running again :3-
|