|
Title: s+ bill accepter Post by: slotmani on November 04, 2013, 11:15:53 PM how do you change out a dbv 145 to a dbv 200 one says 117 volt and the other 12 volt so there must be some wire changes? Are other parts needed?
Thanks ? Title: Re: s+ bill accepter Post by: CVslots on November 05, 2013, 01:01:14 AM 117 volt??? I think you're reading something wrong...that could really get exciting with 117 volts! Both are same, 12 volt. You just swap the head to a DBV200...
Title: Re: s+ bill accepter Post by: knagl on November 05, 2013, 03:43:17 AM However, if your power supply doesn't have vents in it, you need to put in one of the vented power supplies to run a DBV-200. The non-vented supplies don't have enough juice.
Title: Re: s+ bill accepter Post by: Mr. Dinoman on November 05, 2013, 01:04:15 PM Post pictures of the BV's...I guessing the one you have that says 117vac is the 145... :211- I believe some where made for arcades...
Title: Re: s+ bill accepter Post by: slotmani on November 05, 2013, 11:52:02 PM I don't have a camera right now. But one says 12v dc and the other says 117 ac , I don't want to fry any thing, can the 145 be swaped with a 200?
Title: Re: s+ bill accepter Post by: Mr. Dinoman on November 06, 2013, 12:03:30 AM Which BV says what?
Title: Re: s+ bill accepter Post by: slotmani on November 06, 2013, 12:07:11 AM the 145 says 117ac the 200 says 12 v dc both out of different s+ slots
Title: Re: s+ bill accepter Post by: Mr. Dinoman on November 06, 2013, 12:41:14 AM Check the wiring for voltages...I have never seen a S+ with a 145 that used 117vac ...They are supposed to be 12vdc...DO NOT plug in the BV200 you will destroy it if there is 117vac at the connector...You should have a little black power supply next to the BV that supplies 12VDC!...You will need to change that to a vented one for the 200...
Jimmy |