New Life Games Tech Forums

I was going to install my bill sticker on a S-2000 Touch screen machine and remembered (that's a new one for me!) you can't with LED buttons and a touch pad. Other than changing the jumper in the power box to make it lighted all the time, is there another way around the LEDs and make it work?

Ron (r273)

 Ron
If it has led lit bv you can connect the orange wires from the graphics box to the 4 wire power plug going to the led bvboard on the door.
One each orange wire to (Corrected) to the black wire with yellow stripe and the yellow wire with the black stripe pin one and pin four(the wires on the outside edge of the plug)It should the work only when bv is in "ready to accept " mode.
Rich

So I need to splice the two orange wires to 1 and 4? (one is Red and the other is Yellow with black stripe).

Ron (r273)

Splice the orange wires to the black with yellow and yellow with black

Foster has the correct ones I believe they are next to each other on the plug. Let me know(post) the result. I do not think the polarity on the orange wires makes a difference I think it is just looking for potential.

Lots of info in this link (there are also links within lots of information.
http://newlifegames.net/nlg/index.php?topic=3275.msg33257#msg33257 (http://newlifegames.net/nlg/index.php?topic=3275.msg33257#msg33257)

Hey Foster  :259- for correcting my error.

Hope this helps
Rich

Ok, thanks qbert and good old Foster.  :131- Will try it and let you know.

Yeah! It works!  Thank You again.  :wa




Ron (r273)