|
Title: Where is the Volume Setting/control? - Found Post by: John0813 on December 07, 2013, 05:33:09 PM I have a Bally Game Maker, upright, video machine V7200. Just installed a new LCD Screen. The sound is very low...how can I adjust the Sound? Where is the sound volume setting or controls.?? I can go into the Configuration and the sounds all play.. but very low.......
Update...just tried the machine again and now I have NO SOUNDS...Can anyone help?? In short..I went from LOW sound to NO sound....one of the other posts mentioned the 470uF 25 volt capacitor? or any other ideas are appreciated? I waited a half-hour.....tried again.... and now I get a very low sound again!!!! Any advice is appreciated. Thanks Title: Re: Where is the Volume Setting/control? Post by: JMac on December 08, 2013, 03:26:40 AM The volume control is on the MPU board, mounted on the tray just above the monitor.... See attached...
You may or may not have the white plastic shaft on yours, if it is missing, use a small screwdriver... Warning: Never pull or replace the MPU board/tray with the machine powered on... Title: Re: Where is the Volume Setting/control? Post by: John0813 on December 08, 2013, 02:59:32 PM Problem Found....Special thanks to JMac, Slick, and Lucky Slots.....I found the volume control and discovered the long plastic screw was stripped and the volume would not adjust. I used a small screwdriver to turn the control and I heard wonderful sounds.....Again thanks to everyone....you are the greatest... |